You are purchasing one new USA Made alternator to regulator harness kit for 1969 and 1970 Harley-Davidson Servicars. This harness is correct for alternator models not generator models and is for "rear or box-mounted" regulators. This kit also includes the signal light wire which clips into terminal 4 on the regulator clip. We sourced the correct GM Delco terminal housings for the alternator and the four wire regulator. Also has a correct rubber right angle boot for the positive wire to the solenoid.
This was patterned from an NOS sample and is made right here in our shop in beautiful Cimarron, New Mexico, USA! Colors are correct on wires, they are lacquered as original. NOS harness is shown in the last two photos. Overall length is right at 82 inches.
We also manufacture and sell the late 1965-1968 harness for regulators mounted over the coil.
We manufacture wiring harnesses for most USA produced H-D models from 1926-1969, and all Servicars from 1932-1969. If you want a reliable and accurate fit, buy a Cimarron Cycle Works wiring kit. We also carry a large selection of Servicar and 45 solo parts, if you don't see what you need here or cimarroncycleworks, email and ask.
Used on the following models:
- 1969-1970 GE 45" Servicar equipped alternator and voltage regulator.
PLEASE NOTE: When it's practical, I will gladly combine all your purchases into one shipment for a discounted rate.
A note on shipping:
If you would like to take advantage of our combined shipping discounts or shipping promotions, please first add all your items to your shopping cart then proceed to check out and pay for all items at once. Your shipping discount will be automatically figured. Should you need to add an item, we will combine it with your other purchases and issue an appropriate refund to your PayPal account.
We work with a small and select group of vendors and dedicated craftsmen to bring you the very best restoration and repair parts for 1915 to 1984 Harley-Davidson motorcycles. We also offer a huge collection of restoration quality plain head, CP-1038, & CP-1035 bolts; fillister head & round head screws; correctly machined nuts & washers; fuel & oil lines; wiring harnesses; handlebar switches; air cooled spark plugs; clips, clamps, and ties in cadmium, parkerized, zinc, chrome, and raw finishes.
