Harley 1936-45 Knucklehead UL WL Inline Hollywood Handlebars Used OEM

  • Product Code: 293841565282
  • Availability: In Stock
  • $1,700.00


Please read the entire listing before purchasing:

You are purchasing one set of used in line or inline Hollywood handlebars as used from 1936-1945 on big twin Knucklehead and UL and 1940-1957 45" solo and Servicar, I believe. Center casting appears to be an OEM casting, chrome is old with multiple flaws, extra switch holes have been drilled on the underneath side of the throttle side either for turn signals or spot lamps.  

Threads on both ends need to be chased (57/64"-24).  There is the very slightest of a kink or dent shown in photo #8 on the left bar around where the switches are.  It's slight enough that is is not easy to try and capture it with the camera.  I might be overly observant on this and it's not a major issue.  There's some wear on the throttle and advance tracks which is not unusual.  Just note that these will need some work to get back on the road but they are overall a very nice set of very rare handlebars.  

Overall width is approximately 36-37" pull back is approximately 7 1/2" from the centerline split on the middle casting (i.e. the casting that clamps to the forks).

Please study the photos and ask questions, I'm happy to take any measurement needed or to supply more photos.  Returns are a pain in the rear, so make sure you are satisfied with the information and photos in the listing prior to purchasing, and that you have the correct forks these go with.  These will NOT fit 1946-1948 off-set stem forks.

Near offers considered, lowballs will be ignored.

These are priced somewhat less than others I've seen needing about the same or more work to get ready for the road.  Honestly, other than stripping the chrome and re-finishing, and chasing the threads on the bar ends (we do sell that tap) these are going to be a simple project.

Shipping is via UPS ground in the lower 48 states, international shipments will have to go through eBay's Global Shipping Program.

We also currently have a set of OEM offset speedster bars on another listing which are in excellent condition.

We are increasing our Knucklehead offerings, please keep an eye on our page.  We stock a huge assortment of correct hardware for your early Knuckle including hard to find bits as well as a copper oil line set for 1936 only. '36 and '37 oil pressure gauge, coming soon, correct ammeter for these models, fuel lines, saddles, saddlebags, dash parts, engine, fork, clutch, transmission and frame rebuild parts, lighting, wiring harnesses, etc.

If you cannot find what you need here or cimarroncycleworks just email and ask.

Located at and ships from Cimarron Cycle Works in beautiful Cimarron, New Mexico, USA!

Used on the following models, please cross-check your own reference material to make sure this is right for you: 
  • 1936-1945 E, EL, ELS, F, FL 61" & 74" OHV Knucklehead
  • 1940-1952 W, WL, WLD, WR, WLDR, WRTT 45" solo
  • 1940-1957 G Servicar
 

Write a review

Note: HTML is not translated!
    Bad           Good